NS0-184 practice question 14 of 15
You installed a new 4-node AFF A400 ONTAP 9.8 cluster. The AFF400 controller data ports were automatically discovered by “automatic port placement”. In this scenario, which two ONTAP network settings were automatically configured? (Choose two.)
Full set: 60 questionsThe automatic port placement feature, available during cluster setup, simplifies initial network configuration. When ONTAP detects physically connected cluster ports, it automatically groups them into broadcast domains. Subsequently, it creates corresponding subnets and assigns IP addresses from a predefined range (169.254.x.x) to the ports within those broadcast domains. This process establishes the foundational network connectivity for the cluster interconnect without manual intervention.
A. routes: While a default route might be created for a subnet, the automatic port placement feature's primary role is not to configure comprehensive routing tables.
B. IPspaces: IPspaces are logical network containers. The system uses the "Default" IPspace but does not automatically create new ones during port placement.
1. NetApp ONTAP 9.8, Cluster and MetroCluster setup, "How automatic port placement works" section. This guide states, "During cluster setup, ONTAP automatically discovers ports that are connected to the cluster network switches... ONTAP then creates broadcast domains and subnets for the discovered ports."
2. NetApp ONTAP 9.8, Network management, "Overview of network management" section. This document explains that broadcast domains are created to group network ports that are in the same layer 2 network, and subnets are created to assign IP addresses, which is what automatic port placement accomplishes.
Keep practicing
Take the free NS0-184 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other NS0-184 practice questions
- Question 2Which command would be used to measure the throughput and latency of traffic between node…
- Question 3On which type of network interfaces are the cluster interconnect LIFs created?
- Question 4After adding two nodes to an FC-enabled cluster, the storage administrator wants to ensur…
- Question 5You have a 2-node FAS8300 ONTAP 9.8 cluster that serves SMB shares. You are configuring i…
- Question 7You are using Broadcom BES-53248 switches for a cluster interconnect in a base configurat…
- Question 8You have a 4-node ONTAP 9.8 cluster with a FAS8700 HA pair that serves iSCSI LUNs. You ar…
