300-110 practice question 8 of 10

A customer has two Cisco 5520 WLCs that manage all APs throughout the network. The WLCs are in different locations to provide geographical…

Full set: 94 questions
A customer has two Cisco 5520 WLCs that manage all APs throughout the network. The WLCs are in different locations to provide geographical redundancy. A mobility group has been configured on both WLCs and has an UP status on both controllers. The APs in location A are statically configured to use controller A as the primary and controller B as the secondary. If the WLC in location A goes offline, the APs successfully join the WLC in location B, but they do not fail over to their primary configured controller when it recovers. Which configuration task fixes the issue?
Answer options
A: Configure the WLC in location A as primary using the CAPWAP AP Controller IP Address command on all the location A access points.
B: Use DHCP Option 43 and specify WLC in location A as primary.
C: Enable AP fallback globally on the WLC. Correct answer
D: Change the AP Failover Priority to critical.
Correct Answer:
C. Enable AP fallback globally on the WLC.
Explanation

In a Cisco Wireless LAN Controller (WLC) high availability setup, when an Access Point (AP) loses connectivity to its primary controller, it fails over to its configured secondary or tertiary controller. By default, once the AP has failed over, it will remain on the secondary controller even after the primary controller recovers and comes back online. To force the APs to preemptively return to their primary controller upon its recovery, the "AP Fallback" feature must be enabled globally on the WLC. This ensures that APs automatically rejoin their designated primary WLC, restoring the intended load distribution and geographical redundancy design without requiring manual intervention.

Why Incorrect

A. Configuring the primary controller IP on the AP is already done; it does not force the AP to return after a failover.
B. DHCP Option 43 is used for initial WLC discovery, not for controlling post-failover fallback behavior.
D. AP Failover Priority determines the order in which APs fail over when a WLC is oversubscribed, not the fallback behavior.

References

- Cisco Wireless LAN Controller Configuration Guide, Release 8.0. Chapter: High Availability, Section: Configuring AP Fallback.

- Cisco Enterprise Mobility 8.5 Design Guide. Chapter: High Availability, Section: AP Fallback.

Scroll to Top