300-425 practice question 9 of 25
A network consultant must create a wireless design with these characteristics: • Provide coverage in a single contiguous space. • Support dual-band wireless coverage. • Use nine APs for full coverage in a 5 GHz band. What must the engineer do to mitigate co-channel interference and maintain coverage in 2.4 GHz?
Full set: 286 questionsDomain Site Survey
The design is based on the coverage requirements of the 5 GHz band, which has a smaller cell size than the 2.4 GHz band. Placing nine access points (APs) to provide contiguous 5 GHz coverage will result in an overly dense deployment for the 2.4 GHz band. With only three non-overlapping channels (1, 6, 11), having nine active 2.4 GHz radios in the same area will cause severe co-channel interference (CCI). The standard and most effective design practice to mitigate this is to selectively disable the 2.4 GHz radios on some APs. This reduces the number of interfering radios while the remaining active 2.4 GHz radios, with their larger coverage cells, maintain seamless coverage.
A. Adjust the TPC neighbor threshold value to -64 dBm on the 2.4 GHz band. Transmit Power Control (TPC) alone cannot solve the fundamental issue of having nine radios competing for three channels. Aggressive power reduction might create coverage holes, violating a design requirement.
B. Configure static channel and power settings of the 2.4 GHz radios. Static configuration is inflexible, difficult to manage, and prevents the network from adapting to RF changes. It is not a recommended practice for a dense deployment over dynamic Radio Resource Management (RRM).
D. Deactivate low data rates on the 2.4 GHz band. Disabling low data rates is a performance optimization that shrinks cell size, but it does not address the root cause of excessive CCI from too many APs operating on a limited number of channels.
1. Cisco
Enterprise Mobility 8.5 Design Guide.
Reference for Correct Answer (C): In the "High Density WLAN Design Considerations" chapter
under the "2.4 GHz Radio" section
it states: "For 2.4 GHz
it is a best practice to turn off some of the AP radios in a high-density deployment... This allows the remaining 2.4-GHz radios to run at a higher power level
which provides better coverage and performance." (Page 51)
2. Cisco
Radio Resource Management under Unified Wireless Networks White Paper.
Reference for Incorrect Answer (A): The "Transmit Power Control (TPC)" section explains that TPC's goal is to reduce interference and that the threshold defines neighbor relations. However
its primary mechanism is power reduction
which is insufficient for the density described and can negatively impact coverage if set too aggressively. (Section: Transmit Power Control Algorithm)
Reference for Incorrect Answer (D): The "Disabling Lower Data Rates" section describes this as a method to improve performance by removing slow clients and reducing management overhead
effectively shrinking the cell size. It is a secondary optimization
not the primary solution for the severe CCI described in the question. (Section: Data Rates)
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
