300-425 practice question 10 of 25
An architect configures a set of AirOS controllers to be in the same mobility group as the existing controllers. The implementation should facilitate inter-controller roaming for users in their new campus. After the configuration, the mobility tunnel is not operational for the data path in the network. Which two validations should be performed? (Choose two.)
Full set: 286 questionsDomain Mobility
Cisco AireOS Wireless LAN Controller (WLC) mobility groups rely on two distinct communication paths between member controllers. The mobility control path, which handles management and control messages for roaming, uses UDP port 16666. The mobility data path, which tunnels the client's data traffic between the foreign and anchor controllers, uses EtherIP (Ethernet-in-IP), which is identified as IP protocol 97. When the data path tunnel is not operational, a common cause is a network firewall or an Access Control List (ACL) between the controllers blocking these specific protocols. Therefore, a primary validation step is to ensure that firewalls are configured to permit both UDP port 16666 and IP protocol 97.
B. mapping: This is not a standard Cisco term or command related to WLC mobility configuration or troubleshooting.
C. mepping: This is a likely misspelling of the mping diagnostic command, which tests the control path (UDP 16666), not the validation of the firewall rule itself.
D. rping: This is a likely misspelling of the eping diagnostic command, which tests the data path (IP protocol 97), not the validation of the firewall rule itself.
1. Cisco Wireless LAN Controller Configuration Guide, Release 8.5, "Configuring Mobility Groups" chapter, "Information About Mobility Groups" section. The guide states, "Mobility control packets use UDP port 16666 and mobility data is encapsulated using Ether-in-IP (IP protocol 97)." This confirms the specific protocols that must be validated.
2. Cisco Unified Wireless Network Solution: Mobility Architecture - White Paper, "Mobility Control and Data Plane" section. This document details the architecture: "The mobility control plane operates over UDP port 16666... The mobility data plane uses Ethernet-in-IP (IP protocol 97) tunneling to forward data packets from the foreign WLC to the anchor WLC." This reinforces the distinction and necessity of both protocols.
3. Troubleshoot Mobility Issues in a Cisco Unified Wireless Network, "Mobility Ping Tests" section. This Cisco technical note explains that mobility ping test failures are often caused by "firewalls or ACLs blocking the mobility ports (UDP 16666 and IP protocol 97)." This directly links the problem symptom to the required firewall validation.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
