300-425 practice question 25 of 25

A university lecture hall has a Cisco wireless high-density network with this configuration: • 5 GHz only • 20-MHz channels • UNII-1, UNII-2, and…

Full set: 286 questions

Domain Wired and Wireless Infrastructure

A university lecture hall has a Cisco wireless high-density network with this configuration: • 5 GHz only • 20-MHz channels • UNII-1, UNII-2, and UNII2-E channels • TPC minimum = 8 • TPC maximum = 14 The lecture hall is 200 feet by 100 feet and has 16 Cisco APs that use directional antennas. Which feature must be included in the design to mitigate and reduce high-channel utilization from rogue APs?
Answer options
A: band select
B: DFS detection
C: RxSOP Correct answer
D: 802.11w
Correct Answer:
C. RxSOP
Explanation

In a high-density wireless network, co-channel interference is a significant concern, and this interference can be exacerbated by rogue APs. The Receive Start of Packet (RxSOP) feature addresses this by setting a minimum RSSI threshold on the access point's radio. The AP will ignore any 802.11 frames received with a signal strength below this threshold. By raising this threshold, the AP effectively shrinks its listening cell size, making it "deaf" to weak signals from distant rogue APs. This prevents the AP from considering the channel busy due to these distant interferers, thereby directly mitigating and reducing high-channel utilization.

Why Incorrect

A. band select: This feature is used to encourage dual-band clients to connect to the 5 GHz band, which is irrelevant as the network is configured for 5 GHz only.
B. DFS detection: Dynamic Frequency Selection (DFS) is a mandatory mechanism for APs to detect and avoid interfering with radar systems in the UNII-2 and UNII-2E bands, not for mitigating rogue APs.
D. 802.11w: This standard, also known as Protected Management Frames (PMF), secures management frames against spoofing attacks but does not address the issue of RF channel utilization caused by co-channel interference.

References

1. Cisco

High Density Wi-Fi Design and Configuration Guide

Cisco IOS XE Gibraltar 16.12

"RF Features for High Density" section

"Receive Start of Packet (Rx-SOP)" subsection.

This document states

"Rx-SOP is a receiver sensitivity threshold. Any RF signal that is below this threshold is ignored by the AP radio. Rx-SOP is used to reduce the cell size

which is useful in high-density networks. Reducing the cell size helps in improving channel reuse and capacity." This directly supports using RxSOP to ignore unwanted signals (like those from distant rogues) to improve performance in dense environments.

2. Cisco

Radio Resource Management: RF Grouping and RF Profiles

Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide

Cisco IOS XE Cupertino 17.9.x

"Configuring RF Profiles" section.

The guide explains

"The RX-SOP threshold is the level that a client transmission is heard by the AP. If the signal is below the configured level

the AP does not even try to decode the packet... In high-density deployments

this can improve overall system performance by shrinking the cell size." This confirms the mechanism and its application in high-density scenarios to mitigate the impact of weak

interfering signals.

3. Cisco

Enterprise Mobility 8.5 Design Guide

Chapter: "High Density Design Considerations"

Section: "Receive Start of Packet (RxSOP)".

This guide details: "In a high-density environment of APs

it is likely that an AP will hear the transmissions of other APs or clients on the same channel... RxSOP can be used to control the 'hearability' of other transmissions by reducing the receive sensitivity of the AP." This explicitly links RxSOP to mitigating co-channel interference in high-density designs.

Scroll to Top