300-425 practice question 21 of 25

A wireless engineer must design mobility between two buildings at a campus site. The engineer has one controller at each site. The engineer is investigating inter-controller CAPWAP data and control traffic. Which two ports must be open? (Choose two.)

Full set: 286 questions

Domain Mobility

Answer options
A: 5246
B: 5247
C: 8443
D: 16666 Correct answer
E: 16667 Correct answer
Correct Answer:
D. 16666; E. 16667
Explanation

For inter-controller mobility to function correctly, Wireless LAN Controllers (WLCs) within a mobility group must be able to communicate with each other. This communication is divided into two main types: control traffic and data traffic. Mobility control messages, which are used for tasks like exchanging client hand-off information and maintaining the status of other controllers, are sent over UDP port 16666. When a client roams to an access point on a different controller (an inter-controller roam), their data traffic is tunneled between the original (anchor) controller and the new (foreign) controller. This mobility data traffic is encapsulated and sent over UDP port 16667. Therefore, both UDP ports 16666 and 16667 must be open in any firewalls between the controllers.

Why Incorrect

A. 5246: This UDP port is used for CAPWAP control messages between an Access Point and a WLC, not for inter-controller communication.
B. 5247: This UDP port is used for CAPWAP data traffic between an Access Point and a WLC, not for inter-controller communication.
C. 8443: This TCP port is the default for HTTPS management access to the WLC's graphical user interface, not for operational mobility traffic.

References

1. Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide

Cisco IOS XE Bengaluru 17.6.x

Chapter: Configure Mobility

Section: Mobility Architecture.

"The mobility control packets are exchanged over UDP port 16666 and mobility data packets are exchanged over UDP port 16667." This section explicitly details the ports required for inter-controller mobility communication.

2. Cisco Wireless LAN Controller Configuration Guide

Release 8.5

Chapter: Configuring Mobility Groups

Section: Mobility Group Configuration Guidelines and Restrictions.

"Mobility messages are exchanged over UDP port 16666. Mobility data traffic is exchanged over UDP port 16667." This document for AireOS controllers confirms the same port usage.

3. IP Port Numbers Used by Cisco Wireless LAN Controllers

Cisco Technical Note

Document ID: 116345.

This document provides a comprehensive list of ports used by Cisco WLCs. It specifies UDP 16666 for "Mobility Control" and UDP 16667 for "Mobility Data

" while listing UDP 5246/5247 for "CAPWAP" (AP-WLC) and TCP 8443 for "HTTPS for GUI".

Scroll to Top