300-425 practice question 22 of 25
A wireless network consists of: • two IOS XE controllers installed in a data center • 9100 series APs • corporate and a guest WLAN The customer must high availability pair two Cisco WLCs for the client SSO. Which two design approaches must the engineer take to meet the requirement? (Choose two.)
Full set: 286 questionsDomain WLAN High Availability
For establishing a High Availability (HA) pair with Stateful Switchover (SSO) on Cisco Catalyst 9800 series controllers (running IOS XE), specific prerequisites must be met. Each controller requires a unique IP address on its Redundancy Management Interface (RMI) to facilitate communication for heartbeats and state synchronization. Furthermore, both the active and standby controllers must be running the exact same operating system (IOS XE) version. Mismatched software versions will prevent the HA pair from forming, as state information and features may be incompatible, leading to synchronization failures.
A. The controllers must have the same number of licenses. The standby controller inherits all license entitlements from the active controller upon switchover; it is not required to have its own licenses installed.
B. Both WLCs must have the same redundancy management IP address. Assigning the same IP address to two different interfaces on the same network would cause an IP conflict, preventing communication between the controllers.
C. Both WLCs must have the same service port IP address. The service port is for out-of-band management. Like any network interface, if connected to the same network, they must have unique IP addresses.
1. Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide
Cisco IOS XE Cupertino 17.9.x
Reference for Correct Answer E: In the "High Availability SSO: Best Practices and Design" chapter
section "Prerequisites for High Availability
" it states: "Both the controllers must run the same software version."
Reference for Correct Answer D: In the same section
"Prerequisites for High Availability
" it states: "The RMI IP address must be unique on both the chassis."
Reference for Incorrect Answer A: In the "Licensing in High Availability Setup" section
it states: "The standby C9800 does not require any licenses to be installed. All licenses on the active C9800 are inherited by the standby C9800 on switchover."
2. Cisco Catalyst 9800 Series Wireless Controller High Availability Deployment Guide
Reference for Correct Answer D & E: In the "HA SSO Prerequisites" section
the guide explicitly lists: "Both WLCs must be running the same software version" and "The Redundancy Management Interface (RMI) IP address must be unique on both chassis." This confirms the necessity of both conditions for a successful HA SSO deployment.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
