300-425 practice question 19 of 25
An engineer must design and configure a wireless network for: • pervasive coverage in an oil terminal • casual web and email traffic • 5 GHz What is the best design?
Full set: 286 questionsDomain Site Survey
The primary goal is "pervasive coverage" for low-bandwidth applications. To achieve this, the network must allow clients to connect even at the edge of a cell where the signal is weaker. This is accomplished by enabling lower, more robust data rates (like 6 and 9 Mbps), which can be successfully decoded at a lower Signal-to-Noise Ratio (SNR). Disabling these rates would shrink the effective cell size and prevent coverage in fringe areas. Setting the AP power assignment to "auto" engages Radio Resource Management (RRM) features like Transmit Power Control (TPC). TPC dynamically adjusts AP power levels to optimize coverage while minimizing co-channel interference, which is a best practice for stable, large-scale deployments.
A. Disabling 802.11n/ac rates unnecessarily removes high-efficiency modulations and cripples network performance without improving coverage.
B. Disabling data rates below 24 Mbps is a technique used to shrink cell sizes for high-density designs, which is the opposite of providing pervasive coverage.
D. Using the highest static power level (level 1) creates excessive co-channel interference and "sticky client" issues, while disabling lower rates severely limits coverage range.
1. Cisco Enterprise Mobility 8.5 Design Guide
Chapter: WLAN RF Design Considerations
Section: Coverage vs. Capacity. This guide states
"For a coverage-oriented design
the goal is to provide the best possible coverage with the fewest number of APs... This typically means that the lowest data rates are enabled." This directly supports enabling all data rates for a pervasive coverage goal.
2. Cisco Wireless LAN Controller Configuration Guide
Release 8.5
Chapter: Radio Resource Management
Section: Transmit Power Control (TPC) Algorithm. The documentation explains
"The TPC algorithm balances RF power to provide the desired coverage and capacity... TPC seeks to reduce the AP’s transmit power to reduce interference." This confirms that using an automatic power assignment is the correct method for managing coverage and interference.
3. Designing and Deploying 802.11 Wireless Networks
Second Edition (Cisco Press)
Chapter 4: RF Planning and Site Survey
Section: Data Rates. This book explains that lower data rates use simpler modulation schemes (like BPSK) that are more resilient to noise and can be decoded at greater distances from the access point
thereby extending the usable coverage area of the cell. This principle underpins why enabling all data rates is crucial for a coverage-focused design.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
