400-007 practice question 1 of 35
An engineer must design a network for a company that uses OSPF LFA to reduce loops. Which type of loop would be reduced by using this design?
Full set: 397 questionsOSPF Loop-Free Alternate (LFA) is a mechanism under the IP Fast Reroute (FRR) framework. Its primary function is to mitigate packet loss during network convergence. When a link or node fails, OSPF must recalculate the best path, a process that takes time. During this reconvergence period, different routers can have inconsistent routing tables, leading to the formation of transient, short-lived forwarding loops known as micro loops. LFA pre-calculates a backup, loop-free path that can be installed in the forwarding plane instantly upon failure detection, thus avoiding the convergence delay and preventing the formation of these micro loops.
A. DTP (Dynamic Trunking Protocol) is a Layer 2 protocol for negotiating trunk links and is unrelated to Layer 3 routing loops or OSPF.
C. STP (Spanning Tree Protocol) is a Layer 2 protocol designed to prevent broadcast storms and logical loops in a redundant switched topology, not Layer 3 routing micro loops.
D. REP (Resilient Ethernet Protocol) is a Cisco-proprietary Layer 2 protocol that provides fast convergence in ring topologies as an alternative to STP, and is not related to OSPF LFA.
1. IETF RFC 5286: Basic Specification for IP Fast Reroute: Loop-Free Alternates.
Section 1
Introduction: "When a router detects a failure of a link or neighboring router
the router must compute new primary next-hops... During this convergence process
packets may be lost for a variety of reasons. A router may forward a packet to a neighbor that is closer to the failure
and that neighbor may forward it back
resulting in a forwarding loop. This document describes a mechanism that allows a router to rapidly switch to a pre-calculated alternate next-hop..." This forwarding loop described is a micro loop.
2. Cisco IOS XE Fuji 16.9.x
IP Routing: OSPF Configuration Guide.
Section: IP Fast Reroute Using LFA: "When a link or router fails
the routing protocol must re-converge to redirect traffic around the failure. This re-convergence process can take several hundred milliseconds
during which time traffic is dropped. IP fast reroute (FRR) provides a mechanism to quickly reroute traffic around the failure
minimizing packet loss. Loop-free alternate (LFA) is a form of IP FRR that allows a router to precompute a backup next hop for a destination." The traffic drop during reconvergence is a direct symptom of micro loops.
3. P. Francois
C. Filsfils
J. Evans
O. Bonaventure
"Achieving Sub-Second IGP Convergence in Large IP Networks
" ACM SIGCOMM Computer Communication Review
vol. 35
no. 3
pp. 35-44
July 2005.
DOI: https://doi.org/10.1145/1070873.1070878
Section 2.1
Micro-loops: "During the convergence process
different routers can have inconsistent forwarding tables. This can lead to the creation of transient forwarding loops
also called micro-loops. Micro-loops can cause severe packet loss and jitter." The paper then discusses IP FRR mechanisms like LFA as a solution to this problem.
Keep practicing
Take the free 400-007 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 400-007 practice questions
- Question 2Your company wants to deploy a new data center infrastructure Based on the requirements y…
- Question 3You have been tasked with designing a data center interconnect as part of business contin…
- Question 4A service provider hires you to design its new managed CE offering to meet these requirem…
- Question 5Which three Cisco products are used in conjunction with Red Hat to provide an NFVi soluti…
- Question 6You were tasked to enhance the security of a network with these characteristics: • A pool…
- Question 7The network designer needs to use GLOP IP addresses in order to make them unique within t…
