400-007 practice question 7 of 35
The network designer needs to use GLOP IP addresses in order to make them unique within their ASN Which multicast address range should be used?
Full set: 397 questionsGLOP addressing is a method for assigning a globally unique /24 block of multicast addresses to an organization based on its registered 16-bit Autonomous System Number (ASN). As defined by the Internet Assigned Numbers Authority (IANA) and specified in RFC 3180, the address block 233.0.0.0/8 is reserved for this purpose. The 16-bit ASN is mapped into the second and third octets of the 233.0.0.0 address, creating a unique 233.X.Y.0/24 range for the ASN holder, where X and Y represent the two bytes of the ASN.
A. 232.0.0.0 to 232.255.255.255 is the range reserved for Source-Specific Multicast (SSM), where receivers explicitly join a channel from a specific source.
C. 239.0.0.0 to 239.255.255.255 is the Administratively Scoped multicast range, intended for private use within an organization and not globally routed.
D. 224.0.0.0 to 224.0.0.255 is the Local Network Control Block (link-local scope), used for network protocol messages on a single network segment.
1. Meyer
D.
& Lothberg
P. (2001). RFC 3180: GLOP Addressing for 2-Byte ASNs. IETF. Section 2
"GLOP Addressing"
Paragraph 1. Retrieved from https://www.rfc-editor.org/rfc/rfc3180.html#section-2. This document states
"The IANA has assigned the 233.0.0.0/8 address block for this purpose."
2. Cotton
M.
Vegoda
L.
& Haberman
B. (2010). RFC 5771: IANA Guidelines for IPv4 Multicast Address Assignments. IETF. Section 3
"Address Space". The table in this section explicitly lists 233.0.0.0/8 as "GLOP Addresses" and references RFC 3180. It also defines the ranges for SSM (232/8)
Administratively Scoped (239/8)
and Local Network Control (224.0.0.0/24). Retrieved from https://www.rfc-editor.org/rfc/rfc5771.html#section-3.
3. Cisco. (2019). IP Multicast Technology Overview. Cisco Systems
Inc. Under the section "IPv4 Multicast Addresses
" the document describes the different multicast address ranges
including "GLOP addresses (233.0.0.0/8)" for creating globally unique addresses from AS numbers.
4. Holbrook
H.
& Cain
B. (2006). RFC 4607: Source-Specific Multicast for IP. IETF. Section 3
"Protocol-Independent SSM Semantics"
Paragraph 2. This RFC specifies the 232.0.0.0/8 address range for use by SSM. Retrieved from https://www.rfc-editor.org/rfc/rfc4607.html#section-3.
Keep practicing
Take the free 400-007 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 400-007 practice questions
- Question 1An engineer must design a network for a company that uses OSPF LFA to reduce loops. Which…
- Question 2Your company wants to deploy a new data center infrastructure Based on the requirements y…
- Question 3You have been tasked with designing a data center interconnect as part of business contin…
- Question 4A service provider hires you to design its new managed CE offering to meet these requirem…
- Question 5Which three Cisco products are used in conjunction with Red Hat to provide an NFVi soluti…
- Question 6You were tasked to enhance the security of a network with these characteristics: • A pool…
