400-007 practice question 6 of 35

You were tasked to enhance the security of a network with these characteristics: • A pool of servers is accessed by numerous data centers and remote…

Full set: 397 questions
You were tasked to enhance the security of a network with these characteristics: • A pool of servers is accessed by numerous data centers and remote sites • The servers are accessed via a cluster of firewalls • The firewalls are configured properly and are not dropping traffic • The firewalls occasionally cause asymmetric routing of traffic within the server data center. Which technology should you recommend to enhance security by limiting traffic that could originate from a hacker compromising a workstation and redirecting flows at the servers?
Answer options
A: Poison certain subnets by adding static routes to Null0 on the core switches connected to the pool of servers.
B: Deploy uRPF strict mode.
C: Limit sources of traffic that exit the server-facing interface of the firewall cluster with ACLs. Correct answer
D: Deploy uRPF loose mode
Correct Answer:
C. Limit sources of traffic that exit the server-facing interface of the firewall cluster with ACLs.
Explanation

The key constraint in the scenario is the presence of asymmetric routing caused by the firewall cluster. This condition immediately invalidates Unicast Reverse Path Forwarding (uRPF) in strict mode, as it would incorrectly drop legitimate traffic whose return path is through a different firewall or interface. The goal is to prevent a compromised host from sending spoofed traffic to the servers. The most direct and reliable method to achieve this in an asymmetric environment is to use an Access Control List (ACL). By applying an outbound ACL on the server-facing interface of the firewall cluster, you can explicitly define which source IP addresses or subnets are permitted to communicate with the servers, effectively implementing a policy of least privilege and blocking any unauthorized or spoofed source traffic.

Why Incorrect

A. Poisoning subnets with Null0 routes is a technique for black-holing traffic destined for a specific address (DDoS mitigation), not for filtering traffic based on its source.
B. Deploying uRPF strict mode is not viable because the scenario explicitly states that asymmetric routing occurs, which would cause this feature to drop legitimate traffic.
D. Deploying uRPF loose mode is less secure because it only verifies that a route to the source exists in the routing table, not that the source is authorized to access the servers.

References

1. Cisco Systems, "Cisco ASA Series CLI Configuration Guide, 9.1," Chapter: Information About Unicast Reverse Path Forwarding. This document states, "You should not use Unicast RPF on any interface where asymmetric routing is enabled. In the case of asymmetric routing, the return path for a packet is different from its originating path." This directly supports the reasoning for excluding option B.

2. Cisco Systems, "IP Access List Overview," Cisco IOS Security Configuration Guide, Release 15M&T. This guide details the function of ACLs for filtering traffic. It explains that extended ACLs can filter packets based on source address, destination address, and protocol. Applying an ACL to an interface to permit only specific, authorized source networks is a fundamental security practice that directly addresses the question's requirement.

3. Cisco Systems, "Unicast Reverse Path Forwarding," Cisco IOS Security Command Reference. In the description for the ip verify unicast source reachable-via command, the documentation for loose mode (the allow-default option) explains it only checks for the presence of the source address in the FIB. This confirms that it is a weaker check than an explicit ACL, which can validate specific authorized subnets, making option D less effective than option C.

Scroll to Top