400-007 practice question 2 of 35

Your company wants to deploy a new data center infrastructure Based on the requirements you have chosen VXLAN as encapsulation technology The customer is concerned about miss-configuration of Layer 2 devices and DC wide outages caused by Layer 2 loops What do you answer?

Full set: 397 questions
Answer options
A: VXLAN offers native loop avoidance mechanism
B: Storm Control should be enabled on all ports
C: VPC+ could prevent L2 loop on access ports
D: BPDU Guard should be enabled on all VTEP access ports Correct answer
Correct Answer:
D. BPDU Guard should be enabled on all VTEP access ports
Explanation

VXLAN fabrics prevent loops within the overlay network through a Layer 3 underlay and split-horizon logic for BUM (Broadcast, Unknown Unicast, Multicast) traffic. However, the fabric is still vulnerable to traditional Layer 2 loops introduced at the access edge, where servers or external switches connect. The primary mechanism to prevent such loops is enabling Spanning Tree Protocol (STP) features on the VTEP's access ports. BPDU Guard is a critical feature that, when enabled on an access port (e.g., a PortFast-enabled port), will place the port in an err-disabled state if it receives a BPDU. This immediately stops a potential loop caused by an incorrectly connected switch, directly addressing the customer's concern about misconfiguration.

Why Incorrect

A. VXLAN's internal loop avoidance (via L3 underlay and split-horizon) does not prevent loops originating from misconfigured external devices at the access layer.
B. Storm Control is a mitigation feature that limits the rate of broadcast/multicast traffic; it lessens the impact of a loop but does not prevent its formation.
C. vPC prevents loops for specific dual-homing server connections but does not protect against other misconfigurations, like two access ports being connected. "VPC+" is not a standard Cisco term. ---

References

1. Jansen

D.

Krattiger

L.

& Kapadia

S. (2020). Building Data Centers with VXLAN BGP EVPN: A Cisco NX-OS Perspective. Cisco Press.

Chapter 4

Layer 2 Overlays

Section: Spanning Tree Protocol: "To prevent loops

it is a best practice to enable BPDU Guard on all host-facing interfaces. When BPDU Guard is enabled

the switch shuts down the interface if it receives a BPDU from the connected device. This is the desired behavior because host-facing interfaces should never receive BPDUs." This directly supports the selection of option D as a preventative best practice.

2. Cisco. (2023). Cisco Nexus 9000 Series NX-OS Layer 2 Switching Configuration Guide

Release 10.3(x).

Chapter: Configuring Spanning Tree Protocol

Section: BPDU Guard: "The BPDU Guard feature shuts down an interface if it receives a BPDU. You can use BPDU Guard on Port Fast-enabled interfaces to prevent loops. When you connect a device to a Port Fast-enabled interface

the interface comes up and moves directly to the forwarding state. If that device is a switch

you can create a loop." This official vendor documentation confirms the function and purpose of BPDU Guard in preventing loops on edge ports.

3. Cisco. (2023). VXLAN Network with BGP EVPN Control Plane Design Guide.

Section: Layer 2 Tenant Connectivity: This guide emphasizes that while the fabric itself is loop-free

standard Layer 2 best practices must be applied at the edge. It states

"On the access ports that are connected to the servers

it is recommended that you enable the Spanning Tree Port Type Edge (PortFast) feature and the BPDU Guard feature. These features enable the ports to transition to the forwarding state quickly and protect the network from the accidental connection of a switch to an access port." This reinforces that BPDU Guard is a required component for a robust VXLAN deployment.

Scroll to Top