300-425 practice question 15 of 25
A customer has a centralized wireless deployment with N+1 high availability and few open authentication SSIDs configured. After fail over, all APs are broadcasting all SSIDs, but the clients are assigned IP addresses from a different subnet. The WLANs on both WLCs are configured with the same dynamic interfaces. Which feature must be incorporated in the wireless design of the second controller?
Full set: 286 questionsDomain WLAN High Availability
The issue described is that clients receive IP addresses from a different subnet after a failover to the secondary Wireless LAN Controller (WLC), even though the WLANs are mapped to the same dynamic interface names. This indicates a configuration mismatch where the dynamic interface name on the secondary WLC is mapped to a different VLAN than on the primary WLC. VLAN Select, implemented via "Interface Groups," is a feature that load-balances clients for a single WLAN across a pool of VLANs/interfaces. If this feature is used, the interface group on the secondary WLC must be configured with the exact same set of VLANs as the primary WLC to ensure consistent IP addressing for clients post-failover.
A. RF Protocol: This pertains to Radio Resource Management (RRM) and radio frequency characteristics, which have no impact on client VLAN or IP address assignment.
B. AP Groups: This feature controls which SSIDs are broadcast by specific groups of access points. It does not influence the VLAN assignment for clients connecting to those SSIDs.
D. AAA Override: This feature allows a RADIUS server to assign a specific VLAN to a user upon successful authentication. The problem describes an issue affecting all clients on an open SSID, pointing to a WLAN-level misconfiguration, not a per-user override.
1. Cisco Wireless LAN Controller Configuration Guide
Release 8.5
"Configuring Interface Groups" section: "You can configure a WLAN to map to a single interface or to an interface group. An interface group is a logical grouping of multiple VLANs or interfaces. When a WLAN is mapped to an interface group
the wireless client traffic is load balanced across the interfaces in the group." This document explains the VLAN Select feature (Interface Groups)
which
if configured inconsistently between primary and backup controllers
would cause the described problem.
2. Enterprise Mobility 8.5 Design Guide
Chapter: High Availability
"N+1 Deployment Model" section: "The configuration on the primary and secondary controllers should be the same for the WLANs
interfaces
and other parameters... The backup controller must be configured with the interfaces that match the WLANs that are configured on the primary controllers." This official design guide confirms that for N+1 high availability to function correctly
interface configurations must be identical on both the primary and backup controllers. The scenario in the question points to a failure to adhere to this principle
specifically related to the VLANs associated with an interface group.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
