300-425 practice question 14 of 25
An engineer is working for a manufacturing company that has a centralized deployment model. Guests at headquarters need wireless access for…
Full set: 286 questionsDomain WLAN High Availability
In a Cisco Auto-Anchor Mobility configuration, multiple anchor controllers can be assigned to a single WLAN to provide redundancy. The selection of which anchor controller is used for a guest client is determined by the configured anchor priority. The controller with the highest priority (numerically lowest value) is selected as the primary anchor. By setting the primary controller's priority to 1 (the highest possible priority) and the secondary controller to a lower priority (e.g., 2), the foreign controller will always attempt to establish the guest tunnel with the primary first. If the primary anchor is unreachable, the foreign controller will then attempt to connect to the secondary anchor, achieving the desired failover behavior.
B. Set the Anchor priority for the secondary controller to 1. This configuration would incorrectly make the secondary controller the primary anchor, which is the opposite of the stated requirement.
C. Configure ECMP but weigh the cost to be higher to go to the primary. ECMP is used for load balancing clients across anchors with the same priority, not for creating a primary/backup failover model.
D. Configure ECMP but weigh the cost to be higher to go to the secondary. This option incorrectly applies the concept of ECMP and cost. Anchor failover is controlled by priority, not by a routing cost metric.
1. Cisco Catalyst 9800 Series Wireless Controller Software Configuration Guide
Cisco IOS XE Bengaluru 17.6.x.
In the chapter "Mobility Anchor
" under the section "Configuring Mobility Anchor (GUI)
" Step 7 states: "From the Anchor Priority drop-down list
choose a priority for the anchor controller. The valid range is from 1 to 16
where 1 is the highest priority and 16 is the lowest." This directly confirms that priority 1 is the highest and should be used for the primary controller.
2. Enterprise Mobility 8.5 Design Guide.
In Chapter 5
"Mobility Architecture
" the section on "Mobility Anchor Redundancy" explains the failover mechanism: "For guest anchor redundancy
multiple guest anchor WLCs can be configured on the foreign WLC. The foreign WLC uses the first anchor WLC in the list as the primary
the second as the secondary
and so on. If the primary guest anchor WLC fails
the foreign WLC will establish a connection with the secondary guest anchor WLC." The order in the list corresponds directly to the priority setting.
3. Cisco Wireless LAN Controller Configuration Guide
Release 8.5.
In the chapter "Configuring Mobility Groups
" the section "Configuring Auto-Anchor Mobility" details the process. It clarifies that when multiple anchors are configured for a WLAN
the controller with the highest priority (lowest number) is chosen first. If that anchor is down
the next one in the priority list is selected. This supports the primary/secondary model described in the question.
Keep practicing
Take the free 300-425 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 300-425 practice questions
- Question 2A wireless consultant reviewing the installation of an old wireless network. The existing…
- Question 3A company is in the process of relocating to a new force space and ends out that the Inte…
- Question 4An engineer must deploy a wireless network in an open-plan environment that has three SSI…
- Question 5A hospital wireless environment was designed with these characteristics: • RF coverage • …
- Question 6A customer has this wireless design: • two Cisco Catalyst 9800 Series wireless controller…
- Question 7An engineer is implementing a wireless design for a service provider. The design includes…
