300-425 practice question 12 of 25

A customer with two Cisco 5520 WLCs that work as a primary and secondary had some switching issues and the primary controller lost connectivity…

Full set: 286 questions

Domain WLAN High Availability

A customer with two Cisco 5520 WLCs that work as a primary and secondary had some switching issues and the primary controller lost connectivity. Immediately all APs went to discovery and joined the secondary controller. After recovering from the issue, the primary controller is online, but no APs return to it. All APs remain in the secondary controller. Which setting advises the APs to return to their primary controller?
Answer options
A: AP fallback Correct answer
B: AP multicast mode
C: AP heartbeat timeout
D: broadcast forwarding
Correct Answer:
A. AP fallback
Explanation

AP fallback is the specific mechanism that controls whether an access point, after failing over to a secondary or tertiary controller, will return to its designated primary controller once that primary controller becomes available again. By default, this feature is enabled. If APs fail over but do not return to the recovered primary controller, it indicates that the AP fallback feature has been disabled on the secondary controller. Enabling this setting is necessary to advise the APs to return to their primary controller.

Why Incorrect

B. AP multicast mode: This setting determines how multicast traffic is forwarded to APs (multicast or unicast mode) and is unrelated to controller redundancy or AP association logic.
C. AP heartbeat timeout: This timer defines how long an AP waits for keepalives from its current controller before declaring it unresponsive and initiating a failover; it does not control the return process.
D. broadcast forwarding: This is a WLAN-level setting that controls the forwarding of client broadcast traffic and has no impact on the AP's control plane connection to the WLC.

References

1. Cisco Wireless LAN Controller Configuration Guide

Release 8.5

"Configuring High Availability" chapter

"Configuring AP Fallback" section.

The document states

"When the primary controller comes back online

the access point disassociates from the secondary controller and reconnects to the primary controller. This process is called AP fallback. AP fallback is enabled by default." This directly confirms that AP fallback is the setting responsible for the APs returning to the primary controller.

2. Enterprise Mobility 8.5 Design Guide

"High Availability" chapter

"N+1 Deployment Model" section.

This guide explains the N+1 redundancy model and mentions

"When the primary WLC recovers

the APs fall back from the secondary WLC to their primary WLC. The AP fallback feature is enabled by default." This reinforces that AP fallback is the correct term and feature for this scenario.

Scroll to Top