400-007 practice question 21 of 35

A business invests in SDN and develops its own SDN controller that, due to budget constraints, runs on a single controller. The controller actively places an exclusive lock on the configuration of the devices to ensure it is the only source of changes to the environment. What is the result if the controller fails?

Full set: 397 questions
Answer options
A: All device configurations are in read-only mode until the controller is restored. Correct answer
B: The control plane is unavailable until the controller is restored.
C: If a device fails, the configuration backup is unavailable-
D: Manual changes are only possible until the controller is restored
Correct Answer:
A. All device configurations are in read-only mode until the controller is restored.
Explanation

The question describes a custom Software-Defined Networking (SDN) environment with a single controller that enforces a policy of being the "only source of changes" by using an "exclusive lock." This lock is a management plane function. In such a centralized management model, the controller is the single point of truth and control for all device configurations. When this single controller fails, the entity responsible for managing and releasing the configuration lock is no longer available. As a result, no other entity, such as a network administrator, can acquire the lock to make changes via other interfaces (e.g., CLI, SNMP). The device configurations become effectively read-only, a state that persists until the controller is restored.

Why Incorrect

B. While the control plane is also unavailable, this is a general consequence of a controller failure, not the specific result of the "exclusive lock" on the configuration.
C. The operational failure of the controller does not necessarily mean its storage is lost; configuration backups may still be available on persistent storage or a separate system.
D. This is incorrect. The purpose of the exclusive lock is to prevent manual changes. The controller's failure would not suddenly enable them; it would leave the devices in a locked state.

References

1. Cisco Application Centric Infrastructure (ACI) Fundamentals

Release 4.2(x) - Chapter: Cisco ACI Fabric

Section: Cisco APIC. This document describes the Cisco Application Policy Infrastructure Controller (APIC) as the single point of management for the fabric. It states

"The APIC is the single point for all configuration and policy management." If the APIC cluster becomes unavailable

policy and configuration changes cannot be made to the fabric

effectively putting the configuration in a read-only state from a management perspective

which directly supports the principle in the correct answer.

2. Kreutz

D.

Ramos

F. M.

Veríssimo

P. E.

et al. (2015). Software-defined networking: A comprehensive survey. Proceedings of the IEEE

103(1)

14-76. https://doi.org/10.1109/JPROC.2014.2371999. In Section V-A

"Reliability

" the paper discusses the controller as a logical single point of failure. It explains that a controller failure halts the network's ability to evolve or react to new events (a control plane failure)

but also implicitly halts any management plane functions originating from the controller

such as configuration pushes. The inability to make changes until the controller is restored is a primary consequence.

3. RFC 6241: NETCONF Configuration Protocol - Section 8.3: The Operation. While the standard NETCONF lock is session-bound and should be released on session termination

the question implies a broader architectural policy. In systems enforcing a single source of truth

the "lock" is often a persistent configuration pushed to devices to disable other management interfaces. This configuration remains even if the controller's session terminates

thus keeping the device in a read-only state for other managers to prevent configuration drift.

Scroll to Top