400-007 practice question 18 of 35

Which DCI technology utilizes a “flood and learn” technique to populate the Layer2 forwarding table?

Full set: 397 questions
Answer options
A: LISP
B: OTV
C: VPLS Correct answer
D: EVPN
Correct Answer:
C. VPLS
Explanation

Virtual Private LAN Service (VPLS) is a Layer 2 VPN technology that emulates an Ethernet LAN segment over a packet-switched network (typically MPLS). VPLS operates by creating a virtual bridge among provider edge (PE) routers. Each PE router performs MAC address learning based on the source address of frames received from the customer edge (CE) devices. When a PE router receives a frame with an unknown destination MAC address, it floods the frame to all other PE routers participating in the same VPLS instance. This data-plane-driven mechanism is the classic "flood and learn" behavior inherent to traditional Ethernet bridging.

Why Incorrect

A. LISP: LISP is a routing architecture that separates device identity from its location. It uses a control-plane mapping system (Map-Server/Map-Resolver) to find network locators, not a Layer 2 flood and learn mechanism.
B. OTV: OTV (Overlay Transport Virtualization) uses a dedicated control plane protocol (an IS-IS extension) to advertise MAC address reachability, specifically to avoid flooding unknown unicast frames across the DCI core.
D. EVPN: EVPN (Ethernet VPN) utilizes MP-BGP as a control plane to distribute MAC address and IP reachability information. This control-plane learning model is a key advantage over VPLS as it eliminates the need for data-plane flooding.

References

1. Cisco Systems

"Virtual Private LAN Service (VPLS)" (White Paper).

Reference: In the "VPLS Operation" section

it states

"VPLS uses the provider backbone as a huge virtual bridge to connect the remote Ethernet segments. The MAC address learning and forwarding are based on the basic IEEE 802.1d bridge operation. When a PE router receives a packet from a CE router

it learns the source MAC address and stores it in its forwarding table... If the destination MAC address is not in the forwarding table

the PE router floods the packet to all the other PE routers that are part of the same VPLS domain."

Source: Cisco Press

Layer 2 VPN Architectures by Wei Luo et al.

ISBN: 978-1-58705-168-7

Chapter 5: Virtual Private LAN Service. (This book is a widely recognized authoritative source on the topic).

2. IETF RFC 4762

"Virtual Private LAN Service (VPLS) Using LDP Signaling."

Reference: Section 3.3

"Data Plane Operation - Forwarding

" describes the process: "If the destination MAC address is not found in the MAC table

the PE MUST flood the frame... The PE learns the association between the source MAC address of the received Ethernet frame and the PW on which it was received." This officially documents the flood and learn behavior.

DOI: https://doi.org/10.17487/RFC4762

3. Cisco Systems

"Overlay Transport Virtualization (OTV) Technology Introduction and Deployment Considerations" (White Paper).

Reference: The section "OTV Control Plane" explains

"OTV uses a control plane protocol to exchange MAC reachability information between network devices providing Layer 2 connectivity... This approach avoids the need to flood unknown unicast frames over the core." This explicitly contrasts OTV's mechanism with flood and learn.

Source: Document available on Cisco's official website

Design Zone for Data Center.

4. IETF RFC 7432

"BGP MPLS-Based Ethernet VPN."

Reference: Section 5

"Control Plane for MAC Learning

" states

"This document defines a new BGP Network Layer Reachability Information (NLRI) called the EVPN NLRI... A PE can then learn the MAC addresses of the CEs attached to the local PEs from the data path

or it can learn the MAC addresses of the CEs attached to the remote PEs from the control path (i.e.

from the BGP updates it receives from other PEs)." This highlights the primary control-plane learning method that supersedes flood and learn.

DOI: https://doi.org/10.17487/RFC7432

Scroll to Top