400-007 practice question 13 of 35

Company XYZ was not satisfied with the reconvergence time OSPF is taking. BFD was implemented to try to reduce the reconvergence time, but the network is still experiencing delays when having to reconverge. Which technology will improve the design?

Full set: 397 questions
Answer options
A: OSPF fast hellos
B: BFD echo Correct answer
C: Change the protocol to BGP
D: Change the OSPF hello and dead intervals
Correct Answer:
B. BFD echo
Explanation

The network already uses Bidirectional Forwarding Detection (BFD) but requires further improvement in reconvergence time. BFD echo mode is a specific function that can enhance performance. In echo mode, one device sends BFD echo packets to a neighbor, which are then looped back through its forwarding path without being processed by the BFD control plane on the remote system. This reduces the processing load on the neighbor and can allow for more aggressive, lower-latency detection timers than the standard BFD asynchronous mode. By offloading the peer, echo mode provides a faster and more reliable failure detection mechanism, directly addressing the need to improve the existing BFD implementation.

Why Incorrect

A. OSPF fast hellos: This is redundant and less efficient than BFD, which is already implemented and provides superior sub-second failure detection.
C. Change the protocol to BGP: BGP is an Exterior Gateway Protocol (EGP) designed for inter-domain routing and is generally slower to converge than an IGP like OSPF within an enterprise.
D. Change the OSPF hello and dead intervals: BFD has already replaced the OSPF timers as the primary failure detection mechanism, offering much faster detection (milliseconds vs. seconds).

References

1. Cisco Systems

Inc. (2023). IP Routing: BFD Configuration Guide

Cisco IOS XE Bengaluru 17.6.x.

Section: "BFD Echo Mode"

Content: "The BFD echo function runs on the forwarding plane (the line card) and can therefore be used to provide very fast failure detection times... Because the echo function is active on only one side of a link

it can be enabled even if the other side does not support it. The echo function can reduce the BFD-related packet processing load on the remote system." This confirms that echo mode can provide faster detection and reduce load compared to standard BFD.

2. Katz

D.

& Ward

D. (2010). RFC 5880: Bidirectional Forwarding Detection (BFD). IETF.

Section: 6.4. "Echo Function"

Content: "The Echo function is an optional part of the BFD specification... It provides a way to test the forwarding path on the remote system

without involving the BFD process on that system... This can be useful for a number of reasons

including reducing the load on the remote system..." This RFC standardizes the echo function and its purpose of offloading the remote system for potentially faster operation.

3. Cisco Systems

Inc. (2023). IP Routing: OSPF Configuration Guide

Cisco IOS XE Cupertino 17.9.x.

Section: "OSPF Support for BFD"

Content: "BFD is a detection protocol that you can enable at the interface and routing protocol levels. BFD is designed to provide fast forwarding-path failure detection for all media types

encapsulations

topologies

and routing protocols... BFD provides a low-overhead

short-duration method of detecting failures in the path between adjacent forwarding engines." This document establishes BFD as the superior mechanism over tuning OSPF timers (options A and D).

Scroll to Top