400-007 practice question 15 of 35
You are a network designer and you must ensure that the network you design is secure. How do you plan to prevent infected devices on your network from sourcing random DDoS attacks using forged source address?
Full set: 397 questionsUnicast Reverse Path Forwarding (uRPF) in strict mode is the most effective mechanism to prevent source address spoofing from devices within a network. When enabled on an interface, it checks each incoming packet's source IP address against the Forwarding Information Base (FIB). In strict mode, the packet is forwarded only if the FIB has a route to the source IP address that points back out of the same interface the packet was received on. If an infected device forges a random source address, the return path will not match the ingress interface, causing the router to drop the packet and mitigate the attack.
A. ACL based forwarding: This is imprecise. While an access control list (ACL) could manually be configured to permit only valid source subnets, uRPF is the specific, automated, and scalable feature designed for this purpose.
B. unicast RPF loose mode: Loose mode only verifies that a route to the source address exists in the FIB, regardless of the interface. It is less secure and can be bypassed if the forged address is a valid, routable address elsewhere.
D. ACL filtering by destination: This is ineffective for this scenario. Filtering based on the destination address does nothing to validate the authenticity of the source address, which is the core of the spoofing attack.
1. Cisco Systems
Inc.
"IP Addressing: ARP Configuration Guide
Cisco IOS XE Gibraltar 16.12.x"
Unicast Reverse Path Forwarding. This guide states
"Unicast RPF strict mode helps to mitigate problems that are caused by the introduction of malformed or forged (spoofed) IP source addresses into a network... For Unicast RPF to work in strict mode
the router must have a specific route in the FIB that points out the receiving interface."
2. Ferguson
P.
& Senie
D.
"Network Ingress Filtering: Defeating Denial of Service Attacks which employ IP Source Address Spoofing"
RFC 2827
May 2000
Section 1. This foundational document
which uRPF implements
describes ingress traffic filtering to prohibit DoS attacks that use forged source IP addresses. It recommends that providers "prevent traffic with incorrect source IP addresses from entering the network".
3. Baker
F.
& Savola
P.
"Ingress Filtering for Multihomed Networks"
RFC 3704 / BCP 84
March 2004
Section 2. This document updates RFC 2827 and details the uRPF mechanism. It describes strict mode as a check where "a packet is compliant if it is received on an interface that would be used to forward the packet to the packet's source."
4. Kurose
J. F.
& Ross
K. W.
Computer Networking: A Top-Down Approach (7th ed.). Pearson. Section 1.6.2
"Denial of Service (DoS) Attacks". University-level textbooks often discuss source spoofing and ingress filtering (like uRPF) as a primary defense. The principle is to ensure a packet's source address is consistent with its arrival interface.
Keep practicing
Take the free 400-007 practice test
Ten exam-style questions with answers and explanations, plus the exam facts and study guides.
More questions
Other 400-007 practice questions
- Question 1An engineer must design a network for a company that uses OSPF LFA to reduce loops. Which…
- Question 2Your company wants to deploy a new data center infrastructure Based on the requirements y…
- Question 3You have been tasked with designing a data center interconnect as part of business contin…
- Question 4A service provider hires you to design its new managed CE offering to meet these requirem…
- Question 5Which three Cisco products are used in conjunction with Red Hat to provide an NFVi soluti…
- Question 6You were tasked to enhance the security of a network with these characteristics: • A pool…
